9
4.0 REMOVAL OF HOB TOP
4.1 How to Remove Hob Top
4.1.1 Lift off trivets and burner heads.
4.1.2 Pull off knobs.
4.1.3 On 600 Series Flame Failure models unscrew the nut securing each flame failure probe
M7 (
9
/
32
") box socket.
4.1.4 Remove the two screws holding each burner. (To prevent damaging the screw head use a
No. 1 Philips screwdriver.)
4.1.5 Lift off hob top hinging from the back. NB: The edge on stainless models can be sharp. (The
electrodes unplug from the ignition box if you want to get the hob out of the way. They go back
in any order). Disconnect the earth wire from hob terminal.
4.1.6 If you need to change the 600 Series hob, the electrodes may be removed by unlatching the
locating springs.
4.1.7 To replace, reverse the procedure.
To Next Page
Loading...
Need help?
General
