Fisher & Paykel QuickSmart Installation Guide/User Guide

46
PROBLEM DISPLAYED AS WHAT TO DO
The washer is
out of balance.
Wash load is out of balance. Ensure the washer is stationary.
Manually redistribute the load.
Check the washer is level. Refer to ‘Levelling instructions’’ for
more information.
The washer has
too many suds.
The washer has a suds build-up (too much detergent may have
been used for the amount of soil in the load). Wait for suds to
dissolve (about 20min). Rinse clothes using a deep rinse.
Check the standpipe height does not exceed 1200mm.
If the symptom persists, call your Fisher & Paykel dealer or
Fisher & Paykel trained and supported service technician.
The lid can’t
lock or the lid is
open.
Make sure the lid is closed.
Touch
. Refer to ‘Lid lock’ for more information.
If the symptom persists call your Fisher & Paykel dealer or
Fisher & Paykel trained and supported service technician.
The washer is
overloaded.
The washer is overloaded and can not agitate. Ensure the
washer is stationary. Remove items until the remaining ones can
move freely.
Select a higher water level.
The washer has
stopped.
The power was cut to the washer. The washer will restart
automatically. No action is required.
The washer has
stopped.
The or  button was touched and the washer was inactive
for three minutes. The washer will automatically drain to a safe
level. Touch any button to stop autodraining then touch
to
resume the wash cycle.
The washer is on
but the display
is blank.
The washer was unattended without starting a cycle for a period
of time. Touch
to activate.
*The beeps are the same sound your washer makes when you turn it on at the wall.
BEFORE YOU CALL FOR SERVICE

Fisher & Paykel QuickSmart Specifications

General

Brand	Fisher & Paykel
Model	QuickSmart
Category	Washer
Language	English