EasyManua.ls Logo

Fisher & Paykel QuickSmart - Unpacking; Removing the transit bolts

Fisher & Paykel QuickSmart
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
SAFETY AND WARNINGS
MODEL CODE MAX CAPACITY* (KG)
WA7060M 7
WA7060G 7
WA7560E 7.5
WA8560E 8.5
WA8560G 8.5
WA9060G 9
WA1060G 10
WA1060E 10
*Capacity refers to the maximum dry weight of items the washer can wash at any one time.
The WA1060E, WA1060G and WA9060G models have a different capacity based on country
standards. Refer to the serial plate on the back of the product.
z
Do not overload your washing machine beyond its rated capacity.
z
Do not wash an electric blanket in your washer unless the care label specifically states
it is safe to do so.
z
Do not wash curtains in this washer, as sunlight makes them brittle and they may
disintegrate during washing.
z
The only user-removable parts of the washer are the inlet hose(s) and agitator. No other
parts are designed to be removed by anyone other than a Fisher&Paykel trained and
supported service technician.
Installation
z
For guidance on how to install your product, please refer to installation instructions
contained in this document.
Water supply requirements:
z
Inlet water pressure: Max. 1MPa (145psi), Min. 34kPa (5psi)
z
Inlet water flow rate: Min. 8litres/minute
z
A pressure-reducing valve must be installed if pressure is higher than 1MPa.
z
For optimum wash performance check the supply pressure is within the
recommendedrange.
z
New hose sets provided with the washer should be used to connect the washer to the
water mains. Old hose sets should not be re-used.
z
We recommend the inlet hose(s) are changed every 5 years. WARNING: Failure to do so
may result in a flood and damage to property.
z
The hot water temperature should not exceed 65°C and the cold water temperature
not exceed35°C. Temperatures above these may cause the machine to fault or cause
damage to the machine.
z
Install the machine on a solid and level floor surface ensuring it has at least 20mm
clearance on each side. The washer must not be installed on any textured floor
coverings (eg carpet, rugs).
Disposal
z
When disposing of the washer, it is recommended that the lid is removed to
avoidchildren getting trapped inside, and that the electrical cable is cut off
close to thewasher.

Other manuals for Fisher & Paykel QuickSmart

Related product manuals