517790D
11
2.4 Water Temperature Sensing
GW Washer
The thermistor for sensing water temperature in
the GW Washer is located in the back of the
outlet elbow on the valve assembly, and is
connected directly to the Motor Control Module.
For details on the wash temperature adjustment
Refer to Section
2.4.2 & 2.4.3.
Specifications
NTC-type temperature sensor (Thermistor)
Resistance 10,000Ω @ 25
o
C
MW Washer
As there is no thermistor (temperature sensor) in the MW Washer the only temperature that can be
adjusted is the warm wash temperature. The temperature of the warm wash is entirely dependent
on a number of factors:
a. Cold water temperature
b. Cold water pressure
c. Hot water temperature
d. Hot water pressure.
e. Warm wash setting.
As the above will vary from installation to installation it would be impossible to predict what
temperature each installation will ultimately achieve.
However under the conditions outlined below, a temperature of between 36–38
o
C should be
achieved.
Cold water temperature: 20
o
C
Cold water pressure: 320 kPa (46.5 psi)
Hot water temperature: 60
o
C
Hot water pressure: 320 kPa (46.5 psi)
Warm wash setting: Default setting (9 min wash LED – 3rd Green wash LED from the left).
To Next Page
Loading...
