EasyManua.ls Logo

Fisher & Paykel SMARTDRIVE PHASE 7 - Motor, Rotor, and Pump Systems

Fisher & Paykel SMARTDRIVE PHASE 7
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
517790D
14
2.6.1 Manual Water Level – (MW & GW)
The agitator has 5 levels marked on its stem that can be used to help the user select the correct
water level. Select the correct water level by using the mark nearest to the top of the clothes.
The levels marked on the agitator are a guide for the clothes and do not correspond exactly to the
water level.
SmartDrive
may occasionally add water during agitation. This is to maintain the water level due
to the release of air trapped in the garments.
As the MW Washer only has 3 water levels (low, medium and high), if the garments sit between
these levels we would recommend using a lower water level than that of the garments or more
garments be added to the load.
For example: If the garments sat between the medium and high marks on the agitator, choosing a
medium water level would be better than choosing a high water level. Alternatively additional
garments could be added so that the garments were brought closer to the high mark.
SmartDrive
Water Level Settings
Tolerance for each water level = +/- 15mm
2.6.2 Auto Water Level – (GW only)
SmartDrive
automatically selects the appropriate water level for the load when AUTO Water Level
is selected, and will choose one of the pre-existing 5 water levels (low, medium low, medium,
medium high and high). During fill SmartDrive
pauses occasionally to sense the water level.
SmartDrive
checks if the water level is correct by using a series of 2 different agitate strokes. A
slow stroke to sense the load and an agitate stroke to mix the load. If SmartDrive
detects that
that water level is too low it will fill with more water and check the level again.
 When washing an unusual load eg. large bulky garments, pillows, it is recommend that the
water level is manually selected.
 Manually select the water level if there is already water in the bowl.
If SmartDrive
does not fill to the correct level, the water level that SmartDrive
selects can be
modified using Option Adjustment Mode.
High GW712 (54mm)
GW612 (50mm)
MW612 (50mm)
GW512 (60mm)
MW512 (60mm)
Medium High GW712 (105mm)
GW612 (110mm)
GW512
(
115mm
)
Medium GW712 (170mm)
GW612 (175mm)
MW612 (175mm)
GW512 (180mm)
MW512 (180mm)
Medium Low GW712 (245mm)
GW612 (250mm)
GW512
(
255mm
)
Low GW712 (300mm)
GW612 (305mm)
MW612 (50mm)
GW512 (310mm)
MW512 (310mm)

Table of Contents

Related product manuals