EasyManua.ls Logo

Fisher 133L

Fisher 133L
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
133 Series
D100270X012
January 2016
Instruction Manual
Form 5007
133 Series Direct-Operated Regulators
W1327
Figure 1. 133 Series Gas Regulators
TYPES 133H, 133L AND 133Z REGULATORS
W6803
TYPE 133HP REGULATOR
Table of Contents
Introduction...................................................................1
Specications...............................................................2
Principle of Operation...................................................2
Installation.....................................................................3
Overpressure Protection..............................................4
Startup..........................................................................5
Adjustment....................................................................6
Shutdown......................................................................6
Maintenance.................................................................6
Parts Ordering.............................................................11
Parts List.................................................................... 11
!
WARNING
Failure to follow these instructions or
to properly install and maintain this
equipment could result in an explosion
and/or re causing property damage and
personal injury or death.
Fisher
®
regulators must be installed,
operated and maintained in accordance
with federal, state and local codes, rules
and regulations and Emerson Process
Management Regulator Technologies, Inc.
(Emerson™) instructions.
If the regulator vents gas or a leak
develops in the system, service to the unit
may be required. Failure to correct trouble
could result in a hazardous condition.
Call a gas service person to service the
unit. Only a qualied person must install or
service the regulator.
Introduction
Scope of the Manual
This manual provides specications, installation,
adjustment and maintenance instructions and parts
ordering information for the 133 Series regulators.
Only personnel qualied through training or experience
should install, operate and maintain this regulator. If
there are any questions concerning these instructions,
contact your local Sales Ofce before proceeding.
Product Description
The 133 Series direct-operated gas regulators, shown
in Figure 1 are primarily designed for industrial and
commercial applications supplying gas to furnaces,
burners and other appliances. The 133 Series
www.fisherregulators.com
Question and Answer IconNeed help?

Do you have a question about the Fisher 133L and is the answer not in the manual?

Fisher 133L Specifications

General IconGeneral
BrandFisher
Model133L
CategoryController
LanguageEnglish

Summary

Introduction

General Safety Warning

Warns of severe hazards including explosion, fire, and injury if instructions are not followed.

Installation Guidelines

Control Line and Vent Details

Control Line Installation

Specifies the need for and proper installation of the downstream control line for regulator operation.

Overpressure Protection

Overpressure Protection Details

Addresses the need for overpressure protection when inlet pressure exceeds outlet ratings.

Startup Procedures

Startup Safety Precautions

Emphasizes pressure monitoring and avoiding over-pressurizing the diaphragm during startup.

Startup Steps

Provides a sequence of actions for safely placing the regulator into service.

Adjustment and Shutdown

Pressure Adjustment

Explains how to increase or decrease the outlet pressure setting using the adjusting screw.

Maintenance and Disassembly

Maintenance Safety Warnings

Warns against attempting maintenance without isolating pressure and relieving internal pressure.

133 H, 133 L, 133 Z Disassembly

Provides initial steps for disassembling these regulator types, starting with disconnecting lines.

Reassembly Guidelines

Type 133 HP Disassembly

133 HP Disassembly Safety and Initial Steps

Highlights safety warnings and initial steps for disassembling the 133HP model, including disconnecting lines and removing the actuator.

Related product manuals