Instruction Manual
D200129X012
2506/2516 Receiver/Controller
June 2017
10
2. Install lock washers (key 83) on the cap screws (key 48). Then, insert the cap screws through the mounting plate
from “back to front”. Thread the cap screws into the mounting holes in the controller/transmitter.
3. If supply pressure is piped through a filter/regulator, bolt the regulator to the back of the controller/transmitter.
4. Provide appropriate piping connections between the units as shown in figures 10 or 11.
Figure 10. Typical Transmitter with Receiver and Control Valve Installation Assembly
DF5357‐A
A3701‐2
2500 CONTROLLER/
TRANSMITTER
SUPPLY
2506/2516 RECEIVER/
CONTROLLER
FROM DIAPHRAGM
CONNECTION TO
ACTUATOR
DIAPHRAGM
ACTUATOR
CONTROL VALVE
1
NOTE:
1 SEE FIGURE 9 FOR REAR VIEW
1
1
To Next Page
Loading...
