Fisher 2506 - Controller;Transmitter and 2506;2516 Receiver;Controller Mounting

Instruction Manual
D200129X012
2506/2516 Receiver/Controller
June 2017
9
3. Attach the mounting plate with receiver/controller to a 2‐inch (nominal) pipe with pipe clamps (key 175). Each pipe
clamp includes two nuts. Tighten clamp nuts.
4. If supply pressure is piped through a filter/regulator, the regulator may be attached to the mounting plate using cap
screws (key 85), lock washers (key 84), and hex nuts (key 40).
5. Provide appropriate piping from the filter/regulator output connection to the receiver/controller supply
connection.
2500 Controller/Transmitter and 2506/2516 Receiver/Controller Mounting
If the controller/transmitter and receiver/controller are ordered simultaneously, the factory will mount them together
before shipment (figure 9). For examples of typical transmitter/receiver mounting arrangements, see figures 10
and 11.
If the receiver/controller is ordered separately for use with a 2500 controller/transmitter, it may not have the required
mounting parts. If mounting parts are required, consult the parts list under the specific mounting application.
See figure 9 for key number locations.
Figure 9. Fisher 2500 Controller‐Transmitter and 2506/2516 Receiver‐Controller Mounting
AR5748‐B
3V7594‐B
B2115‐1
TUBING
(KEY 169)
TUBING
(KEY 168)
TRANSMITTER
OUTPUT
OUTPUT
CONNECTION
(MARKED
DIAPHRAGM)
1/4 NPT SUPPLY
(ON REGULATOR)
MOUNTING PLATE (KEY 164)
CAP SCREW AND LOCKWASHER
(KEYS 39 AND 83)
BELLOW VENTS OR REMOTE
SETPOINT CONNECTION
INSTRUMENT INPUT
CONNECTION
SUPPLY CONNECTION
1/4 NPT REMOTE
LEVEL INDICATOR
REAR VIEW
406
(16.00)
60
(2.37)
235
(9.25)
FRONT VIEW
mm
(INCH)
1. Install lock washers (key 83) on the cap screws (key 39). Then, insert the cap screws through the mounting plate
from “back to front”. Thread the cap screws into the mounting holes in the receiver/controller case and tighten.