2
Table 1. Specifications
Valve Sizes and End Connection Styles
NPS J 2, J 3, J 4, J 6, J 8, J 10, and J 12 valves
in wafer or single flanged style (NPS 2 available in
wafer style only)
Maximum Inlet Pressures
(1)
Carbon Steel, Stainless Steel, and CN7M Valv es:
Consistent with CL150 and 300 pressure-temperature
ratings per ASME B16.34, unless limited by material
temperature capabilities. NPS 2 is also consistent with
CL600
Maximum Pressure Drops
(1)
Consistent with CL150 and 300 pressure/
temperature ratings per ASME B16.34 except for
PTFE, UHMWPE, and Phoenix III seals that are derated
at some higher pressure/temperatures values. (See
figure 2)
Shutoff Classifications
J PTFE, Reinforced PTFE, and UHMWPE
(2)
Seal: No
visible leakage for this bidirectional seal per MSS
SP-61
J NPS 2 Metal Seal: Bidirectional shutoff. 0.001% of
maximum valve capacity (1/10) of Class IV per
ANSI/FCI 70-2 and IEC 60534-4. Pressure Drop is 740
psig forward and 100 psig reverse
J NOVEX Seal: Unidirectional shutoff is MSS SP-61 in
the preferred flow direction
J Phoenix III Seal: No visible leakage for this
bidirectional seal per MSS SP-61. For optional Phoenix
III Fire-Tested seal, consult your Emerson Process
Management sales office
Flow Characteristic
Approximately linear
Flow Direction
See figure 4
Disc Rotation
Clockwise to close (when viewing the drive shaft end)
through 90 degrees of disc rotation (see figure 7)
Valve Classification
Face-to-face dimensions of NPS 3 through 12 in
CL150 or 300, and meets API 609 or MSS-SP68
standards for face-to-face dimensions of wafer-style
and single-flange valves
Actuator/Valve Action
With the diaphragm or piston actuators, the valve
action is field-reversible. Refer to information in the
Installation section and in figures 6 and 7.
Shaft Diameters
See table 2
Approximate Weights
See table 2
ENVIRO-SEAL Packing
This optional PTFE or graphite packing system
provides excellent sealing, guiding, and transmission
of loading force to control liquid and gas emissions
(see figure 6). See Bulletin 59.3:041 ENVIRO-SEAL
Packing System for Rotary Valves for more
information
1. The pressure/temperature limits in this manual and any applicable standard or code limitation for valve should not be exceeded.
2. UHMWPE stands for ultra high molecular weight polyethylene.
To Next Page
Loading...
