14
Fig.5.8 Sleep setting
Sleep off is default after power failure and then power recovery. There is not sleep function in fan and
auto mode.
Note:
In cooling and dry mode, if the unit with sleep function has run for 1 hour, the preset temperature will
be increased by 1℃ and 1℃ in another 1 hour. After that, the unit will run at this temperature. In heating
mode, if the unit with sleep function has run for 1 hour, the preset temperature will be decreased by 1℃
and 1℃ in another 1 hour. After that, the unit will run at this temperature.
Turbo function: The unit at high fun speed can realize quick cooling or heating so that room
temperature can quickly approach setting temperature.
In cooling or heating mode, press Function button till the unit enters turbo function and then press
Enter/cancel button to turn on turbo function.
During turbo function, press Function button till the unit enters turbo function and then press
Enter/cancel button to cancel turbo function.
Turbo function setting is shown in Fig5.9：
5.9 Turbo Function Setting
To Next Page
Loading...
Need help?
General
