16
Fig.5.10 Energy Saving Setting
Note：
1．In Auto running mode with save function on, the unit will be forcibly changed to corresponding
mode. After setting of save, sleep function will be canceled.
2. In save mode, if Function button is pressed or there is not any operation within 5s after the last
button operation, the system will quit from save function setting and current data won’t be memorized.
3. After power failure and then recovery, save function setting will be memorized.
4. The lower limited value in cooling mode is 16℃ and the upper limited value in heating mode is
30℃.
5. After save setting, if the setting temperature is out of the range in the mode, the limited value will
prevail.
There is no this function for this unit
E-heater: In heating mode, E-heater is allowed to be turned on for improvement of efficiency.
If heating mode is turned on by button operation, auxiliary electric heating function will be
automatically turned on.
Press Function button in heating mode into auxiliary electric heating function, E-HEATER blinking,
and press Enter/cancel button to turn on this function. In this case, E-HEATER will be displayed, which
means E-heater is allowed to be turned on.
5.11 E-heater setting *
To Next Page
Loading...
Need help?
General
