21
card.
If memory function is on, the unit after plugging out of card and then plugging in will run according to
the memory. If the card is not plugged in (or poor plugging), the mark
will show and the unit will be
turned off.
If memory function is off, the unit after plugging out the out will be turned off and the mark will
show. If re-plugging in the card, the mark will disappear and the unit enter will enter off state.
Note:
1. During long-distance monitoring, the unit on /off can not be controlled by the card, but the mark
will also show after plugging in the card.
2. The unit can not be controlled by button operation after plugging out the card.
Under on or off state of the unit, press Enter/Cancel button for 5s, outdoor ambient temperature will
be displayed at temperature displaying area after a sound of click .Pressing any button, this enquiry
state will quit. If there is not any operation for 20s, it will automatically quit.
Note：
1. This function will be shielded after energization of 12hr for some models of the units without
outdoor ambient sensors. Please refer to Instruction for details.
2. If malfunction of outdoor ambient sensor occurs, this function will be shielded in 12hr.
Under off state of the unit, press Mode and ▼ at the same time for 5s, the displayer panel will
switch between Centigrade and Fahrenheit.
5.15.4 Enquiry of Outdoor Ambient Temperature
5.15.5 Selection of Centigrade and Fahrenheit
To Next Page
Loading...
Need help?
General
