Name: Fisher Gold Bug
Brand: Fisher
Rating: 5 (1 reviews)

To Next Page

To Previous Page

BATTERY REPLACEMENT

Two nine volt transistor batteries are located in separate

compartments at the rear of the housing. When it's time to

replace batteries, always replace both of them.

1. To open, press gently down on the battery door

latch. The doors are hinged, do not attempt to

completely remove them.

2. Tilt the housing gently and the batteries will slide out.

3. Insert the new batteries. Make sure the contact

end goes in first and that you match the polarity

markings on the control housing.

4. To close, simply hook the lower edge of the

battery door over the inside of the battery

compartment and gently push shut.

5. Push the latch up to make sure it has snapped

into place.

Battery replacement is simple: just pop the doors,

slide the old batteries out and the new ones in.

Figure 7. Battery Replacement

Other manuals for Fisher Gold Bug

Questions and Answers:

Need help?

Do you have a question about the Fisher Gold Bug and is the answer not in the manual?

General