9
Pinpointing takes practice. The more time you spend with your
1212-X the faster and more accurate you’ll become.
1. Once a buried target is indicated by the tell-
tale “beep” of the 1212-X, continue moving the
search coil from side-to-side across the target in a
narrower and narrower search pattern.
2. When you have narrowed your search pattern
as much as you can, and still hear the target, stop
the search coil.
3. Now, move the coil slowly forward and then
straight back towards you a couple of times. Stop
the coil over the area where you get the loudest
response.
4. Move the coil slowly side-to-side one more time,
zeroing in on the loudest target response.
5. Stop the coil over the area of loudest response
and rest it on the ground.
6. Your target should be below the “Hot Spot” of
the search coil which is marked by a bull’s- eye,
slightly below the center of the coil.
7. Slowly move the coil aside, keeping your eyes
on the spot where the “Hot Spot” was and quickly
mark the target location with your finger or
digging tool.
8. For very strong signals, you may improve your
pinpointing accuracy by adding one or more of
the following steps:
a. Lift the coil until the signal is just barely heard.
b. Increase the discrimination level.
c. Rest the coil on the ground and move it back
and forth very slowly.
9. For very weak signals try the following:
a. Move the coil closer to the ground.
b. Decrease the discimination level.
c. Speed up the sweep rate slightly.
10. The diagram on page 10 shows the search
coil detection pattern and how it is affected by
various sweep speeds, trash rejection and ground
mineralization levels.
PINPOINTING
To Next Page
Loading...
Need help?
General
