21
SHALLOW WATER STEPS
Place your FishHunter in water for it to turn on.
The sonar will have a red light appear and an additional
slow flashing red light to identify that it is on.
On your Smartphone/Tablet open your Wi-Fi settings.
Refresh the list and select "FishHunter Wi-Fi XXX"
( Note: this can take up to 1 minute )
Open the FishHunter app on your smartphone or tablet and go
into the sonar section.
Select your prefered view.
Pull out your side menu.
On the range settings, select Shallow Water.
( Note: you must adjust the power slider to ensure you have the
right amount of power for your area. Failure to adjust power can
cause your FishHunter not to find the bottom correctly. )
You can pull down the top menu to select raw or fish view, select
the units of measurement, drop a pin or take a screenshot.
1
2
3
4
5
6
7
8
To Next Page
Loading...
