9
Once connected, open the FishHunter App and go to the
Sonar section.
Select one of the following functions you would like to use:
Start Fishing: allows you to use the sonar and offers dif-
ferent view modes. Press on one of these modes to activate
your sonar.
i. Fishing
ii. Bathymetric Mapping
iii. Ice Fishing
Demo Mode: will allow you to see how the sonar will work
when not connected to a sonar.
The slow red flashing light on your sonar will start flashing
quickly when connected and sending information to your phone
or tablet.
The unit will automatically power down and turn off when not in
the water after a few minutes. If the lights remain on after it is
removed from water, please ensure the charging pins are free
from any water or debris by blowing on them. Additionally, you
can insert and remove the charging cord and that should enable
the sonar to power down after 60 seconds. If the units still
remains on, then double check that your wifi is turned off and
repeat the above.
YOU CAN RESET YOUR SONAR AT ANY TIME BY INSERTING THE
CHARGE CORD INTO THE BOTTOM OF THE UNIT AND REMOVING IT.
9
10
11
12
To Next Page
Loading...
