2022 Fisker Ocean
3. Disable Direct Hazards / Safety Regulations
31
Disabling the 12-Volt System
WARNING: Always use appropriate tools and wear appropriate PPE when
cutting the 12V ground cable. Failure to follow these instructions can result in
serious injury or death.
WARNING: Cutting the 12V ground cable DOES NOT completely disable the
high-voltage system. Continue to treat the high-voltage components as
energized even after disabling the 12V system.
1. Turn the vehicle OFF. See Powering Off, page 21
.
2. Access the 12V battery. See Accessing the 12V battery, page 14
.
3. Locate and double-cut the 12V ground cable that runs from the 12V battery
negative terminal. Be sure to cut out a section of cable that is wide enough to
prevent the cut ends from accidentally touching and completing the electrical
circuit.
4. If time allows, wrap the cut ends of the cable in electrical tape as an additional
precaution against accidental reconnection.
To Next Page
Loading...
