FISNAR DC50 - Product Safety Statements

DC50 Digital Dispenser Operating Manual
© 2020 Fisnar - 4 - DC50 Rev 02
General Precautions
Do not operate the machine in excess of its maximum ratings / settings.
Make sure that the input air supply is clean and dry. A 5 micron air filter/regulator
(item number 560567) is recommended to ensure the input air supply is clean
and dry.
If corrosive or flammable fluids are being used, an inline filter (item number
5606037) must be installed to help prevent the fluids from being sucked back
into the machine.
The fluid being dispensed may be toxic and / or hazardous. Refer to the Material
Safety Data Sheet for proper handling and safety precautions.
Do not smoke or use near an open flame when flammable materials are being
dispensed.
Do not expose the machine directly to sunlight.
Avoid cleaning the machine with aggressive solvents – neutral detergents are
preferred.
Do not overfill the syringe barrel and/or lay the syringe barrel on its side. This
will prevent fluids from flowing back into the machine – refer to figures A & B
below.
DC50 Malfunction
If the machine malfunctions, shut down the machine immediately. This can be
done by either pushing the power switch at the back of the unit into the off
position or disconnecting the power cord.
Always use a piston with the syringe barrel to prevent fluids from flowing back
into the machine
When dispensing low viscosity fluids that require the vacuum, be aware not to
increase to a point where fluids begin to run back into the air line potentially
reaching the control box. The vacuum should not be set too high or it will cause
material to creep backwards.
SAFETY