What to do if pump is air-locked and P1 and/or P2 FLOOD LIMIT is displayed on Flamco Portable Generator?
If the relevant pump on your Flamco Portable Generator is air-locked and not pumping water, and P1 and/or P2 FLOOD LIMIT is displayed, try bleeding the pump.
How to increase system pressure on flamco Mini 130D Portable Generator?
If the system pressure of your Flamco Portable Generator has fallen, increase the system pressure using a filling loop, or enable the SYSTEM FILL option.
What to do if PUMP TYPE option is set incorrectly on flamco Mini 130D Portable Generator?
If the PUMP TYPE option is set incorrectly on your Flamco Portable Generator, review the PUMP TYPE setting.
What to do if P2 FAIL is displayed on single pump model of flamco Mini 130D?
If P2 FAIL is displayed on your Flamco Portable Generator, but it's a single pump model, the PUMPS NUMBER option is likely incorrectly set to 2. Set PUMPS NUMBER to 1.
What to do if pump has failed on flamco Mini 130D?
If the relevant pump has failed on your Flamco Portable Generator, replace it.
What to do if LOW PRESSURE fault is displayed and pumps do not run on flamco Mini 130D Portable Generator?
If the LOW PRESSURE fault is displayed and the pumps do not run on your Flamco Portable Generator, and the SPC CONTROLLER option is enabled, disable the SPC CONTROLLER option. Also, review the system specifications if the LOW PRESSURE set point is too high.
Outlines how to connect the mains power supply safely and correctly.
Lists essential checks to perform before starting the commissioning process.
Guides on entering codes and navigating through the controller's programming menu.
Details each menu item, its function, and default value.
Covers settings for experienced engineers like PUMP TYPE, SENSOR TYPE, CASCADE.
Procedure for bleeding air from the pumps.
Shows bleed screw locations and warnings for bleeding pumps.
Explains how to manually run pumps for bleeding.
Details opening the isolation valve and how the unit responds to system pressure.
Method for testing operation by slowly reducing system pressure.
Lists and explains all fault codes displayed on the digital controller.
Steps to safely shut down the pressurisation unit.
Solutions for 'LOW PRESSURE' displayed and pumps not running.
Solutions for 'P1/P2 FAIL' and pump not making pressure.
General| Brand | flamco |
|---|---|
| Model | Mini 130D |
| Category | Portable Generator |
| Language | English |
To Next Page
