FLARM ATOM UAV - Appendix A: List of Error Codes

ATOM UAV MANUAL
Date: 2021-10-28
Version: 1.1
Page: 33 of 35
FLARM Technology Ltd
Hinterbergstrasse 15
CH-6330 Cham
Document Number:
FTD-088
Appendix A – List of Error Codes
The table below lists the error codes that can be indicated and their meaning. The
hexadecimal value of the error code is shown. Some displays may instead indicate
the decimal value and/or a text description. The possible error code range is from
0 to FFF.
Error Code (Hex)
Meaning
11
Firmware expired (requires valid GNSS information, i.e.,
will not be available during the first minutes after power-
on)
12
Firmware update error
21
Power (e.g., voltage below minimum)
22
UI error
23
Audio error
24
ADC error
25
SD card error
26
USB error
27
LED error
28
EEPROM error
29
General hardware error
2A
Transponder receiver Mode-C/S/ADS-B unserviceable
2B
EEPROM error
2C
GPIO error
31
GNSS communication
32
Configuration of GNSS module
33
GNSS antenna
41
RF communication
42
Another FLARM device with the same Radio ID is being
received. Alarms are suppressed for the relevant device.
43
Wrong ICAO 24-bit address or radio ID
51
Communication
61
Flash memory
71
Pressure sensor
81
Obstacle database (e.g., incorrect file type)
82
Obstacle database expired
91
Flight recorder
93
Engine-noise recording not possible
94
Range analyzer
100
Generic error
101
Flash File System error
110
Failure updating firmware of external display
120
Device is operated outside the designated region; the
device does not work
F1
Other