Flashforge Adventurer 4 - Page 10

10
English
Changing filament
1. Press Prepare 2. Press Filament 3. Press Change 4. The extruder will
heat up. Once
the extruder
has heated up,
the filament will
automatically be
feed out.
5. Open the hatch.
6. Remove the current
filament reel and pull
the rest of the filament
from over the feed
wheel.
7. Fit the new filament
and pass it over
the feed wheel.
8. Press Next and then Next again. The filament feeds automatically.
9. Press Complete when you see filament coming out of the extruder.
If the extruder becomes clogged. See cleaning instructions on the supplied
USB stick.