Flashforge Adventurer 4 - Page 4

4
English
• Printed models should never be exposed to any type of heat, such as that
emitted by cookers, ovens, fires and candles.
• Turn off theproduct and unplug it from thewall socket immediately if:
- theproduct begins to emits smoke or smells burnt
- theproduct emits unusual sounds
- metal or any types of liquid comes into contact with theproduct
- there is apossible risk of thunderstorms
- there is apower cut
• This product contains moving parts that can cause personal injury and parts
which reach temperatures of 200−300 °C.
Keep all parts of your body away from theprinting area when theproduct is in
operation. Never touch theprint head while printing is in progress.
• Let theproduct cool down completely after use before handling it.
• Never attempt to bypass any safety mechanisms that prevent user access to
theprinting area and print head.
• Printed models are extremely hot after being printed. Always let themodels
cool before they are handled.
• Never leave theproduct unattended while it is operating.
• Never let children play with theproduct. Never let children use theproduct
without adult supervision. Adult supervision is always required in order to
ensure safe operation.
• Keep all models out of thehands of small children. Models pose achoking hazard.
• Printed models should never be used for food storage.
• Printed models should never be used for electrical installation purposes.
• Never print models that might break laws or regulations in thearea where
theproduct is used.
Warning: Hot surfaces
Warning: Crush hazard
Warning: Electric shock hazard