Flashforge Guider IIs - Unpacking the Guider IIs

ServoServoServo
HeatingHeating
TubeTube
Heating
Tube
3
5
1. Unplug the blue thermocouple. （②）
2. Loss the two screws fixed the heating
tube nest by using straight screwdriver
and unplug heating tube nest. （③）
3. Remove the two screws fixed the leveling
servo by using cross screwdriver, and remove
the servo. （⑤）
4. Unplug the nest of leveling servo. （④、①）
5
Servo
Screw
Servo Nest
Heating Tube
1
2
3
4
Blue
Thermocouple
Heating Tube
04
Step 3