Why does the water from my Fleck 5600 Econominder Control Unit not feel soft?
Check the salt level in the brine tank of your Fleck Control Unit, and ensure that the salt level is maintained above the water level. If the issue persists, it is recommended to contact your local water service technician.
What to do if there is a power outage with my Fleck 5600 Econominder?
In the event of a power outage, reset the Time of Day on your Fleck Control Unit. Consult the “Setting the Time of Day” page for instructions.
Guides on initial setup and installation of the water softener.
Details how to set time, hardness, and people for automatic regeneration.
Addresses common problems like regeneration failures, hard water, and salt usage.
Covers issues with water pressure, flow control, drain lines, and timer/valve malfunctions.
Discusses filter backwashing, iron bleeding, and meter measurement problems.
General| Service Capacity | 48, 000 grains |
|---|---|
| Regeneration Cycle | Adjustable |
| Mounting | Top Mount |
| Operating Pressure | 20 - 125 psi |
| Regeneration Type | Meter Initiated |
| Power Supply | 120V AC |
| Valve Size | 1" |
| Brine Draw Flow Rate | 0.5 GPM |
| Materials | Noryl |
| Operating Temperature | 34 - 110°F |
To Next Page
