LillillJCj
WiTh
YOUR
MOTOR
HOME
The monitor panel allows you to conveniently check the
approximate levels in the water tanks and
to
check battery
condition(s).
It
is located in the driver's area
of
the dash.
Electrical probes installed in the tanks measure the levels at
various points in the tanks.
To
check tank levels:
Press "LEVELS TEST" switch.
The E or empty indicator
light will always be lit when the rock-
er switch is depressed.
If
the tank
is
full, all lights will be on.
Lights are
sequential, and indicate level in approximately
1/4-tank increments. If the tank selected
is
approximately
3/4-full,
for example, lights
E,
1/4, 1/2 and 3/4 will be on.
Erroneous tank level indications can
be
caused by:
a.
Water with low mineral content. The level is measured by a
very
low level electrical signal traveling through the liquid.
Some
water may not conduct the signal properly. This con-
dition may be infrequent, but can exist. Check the
panel
reading when the fresh water tank
is
filled.
b.
Material trapped on the sides of the holding tanks may give
a
full reading when the tank
is
actually empty.
c.
Motor home not level.
To
check the main (house) batteries:
1.
Unplug the 120-volt AC shore cord and turn off the genera-
tor and chassis engines.
2.
Turn on a light or any 12-voit appliance. The battery must
be checked with a
load.
3.
Press BATTERY rocker switch on the panel.
4.
Read battery condition on the meter.
04,8
MONITOR
PANEL
NOTE
If
the
sensor probes
mounted
in
the tanks get
coated
with
grease, the
monitor panel may indi-
cate falsely
or
not at all.
Avoid pouring grease,
oils or similar substances
down
drains
or
the
toilet.
If
this
is
unavoidable, the
holding tank(s) should be
washed out with
a soapy
water solution. See your
dealer for additional
information.
BOUNdER
DiESEL
To Next Page
Loading...
