PlUMbiNq
SYSTEMS
To
disconnect the city water:
1.
Turn OFF the city water supply.
2.
Remove the hose from the city water supply valve.
3.
Drain and store the hose on shelf provided.
The on-board fresh water tank can be filled in two ways: (1)
city water pressure or (2) gravity.
1. City water pressure - When connected
to
the city water
supply as described above, turn the bypass valve located in
the utility compartment to
"Water Tank Fill" from the
"Normal" setting. This will fill the on-board fresh water tank.
Make sure the external gravity
fill connection
is
open
(remove the cap) to
allow air to escape from the on-board
tank. When water
flows out of this external fill, the on-board
tank is
full.
After filling, turn the bypass valve
to
"NormaL"
2.
Gravity fill
-The
external gravity water fill is located on the
exterior of the motor home. The on-board water tank can
be
filled here.
To
fill the fresh water tank, remove the cap and
fill the tank using a potable water hose.
Check the monitor
panel often to determine if the tank
is
full.
If
water
is
flowing from the top vent, your tank
is
over-
filled. Stop filling.
Avoid leaving the water in the tank when the motor home
is not in use.
To
drain the fresh water tank, open the cold
low point drain valve located in the basement utility
compartment.
FILLING
THE
ON--BoARD
WATER
TANK
CAUTION
Overfilling the fresh water
tank from a pressurized
source will cause serious
damage to the water tank
or structural components.
Monitor water tank filling
continually.
,
f--
To Next Page