LiviNq
WiTh
YOVR
MOTOR
HOME
Closets may be equipped with 12-volt lights that turn ON
when the closet door is opened. Be sure the light goes OFF
when the closet door is
closed-your
battery will be dis-
charged
if
it stays ON.
If
the light stays on when the door is
closed, the door switch requires adjustment. The same load-
ing considerations apply
to
interior storage areas
as
to exteri-
or.
Consult the Motor Home Loading section in the On The
Road
chapter.
The materials used inside your motor home have been select-
ed for durability and comfort. With reasonable care, these
materials will stand up under years
of
recreational living.
The
Maintenance chapter in this manual outlines care
requirements for the various upholstery fabrics, floor, cabi-
net, and wall finishes.
To
convert the dinette into a bed:
1.
Unfasten and remove cushions.
2.
Remove front and rear dinette seat rails.
3.
Reach under the table. Either remove leg or fold
it
up under
the
table top.
4.
Raise the front portion of table several inches to disengage
inserts from the
wall supports.
5.
Lower table top to the dinette frame to complete bed base.
6.
Slide seat and back cushion into place over bed base.
To
convert a sofallounge into a bed:
1.
Lift front of sofa frame up and out.
2.
Push the back of the sofa back and down.
3.
Push the seat belts through the space between the sofa
back and seat.
PACE AI/I/ow
INTERIOR
AND
FURNISHINGS
DINETTE
CONVERSION
To Next Page
Loading...
Need help?
General
