PIUMbiNq
SYSTEMS
The black water holding tank is equipped with rinsing spray
heads that will aid in the removal
of
sewage residue from the
interior
of
the holding tank.
To
operate the tank flushing sys-
tem, follow the procedures for
Dumping The Holding Tanks
in this chapter. After dumping the gray water tank proceed as
follows:
1.
Connect a garden hose to the
6"
stub hose with the quick
connect coupler.
2.
Insert the quick connect coupler into the flush inlet. This
connection is labeled, "SEWER
VALVE
MUST BE OPEN
WHEN USING THIS INLET."
3.
Open the black water sewer valve. THIS
VALVE
MUST BE
OPEN.
4.
Open the water valve at the quick connect coupler and at
the water
supply.
5.
Rinse the tank for 2-3 minutes or until the water
is
running
clear from the sewer hose.
6.
Turn off the fresh water and disconnect the hose.
7.
After rinse water has thoroughly drained from the black tank
close the knife valve and replace the termination cap. If you
are parked at a site with a semipermanent sewer hookup,
keep the
black water knife valve closed to allow the waste
level to build
up.
The outlet will probably clog if you leave
the knife valve open continually. Run enough water into the
tank to
cover the bottom. This will aid the break up of solid
wastes.
Please
...
Practice good housekeeping when draining wastes
at a campsite
or
disposal station. Leave the site in good
order. Above all,
do
not pollute.
BLACK
TANK
FLUSH SYSTEM
CAUTION
Do
not use the same
hose
you
use for filling
the
potable water tank, or
for
connection
to
the
city
water
inlet. This
is
espe-
cially true
if
you
the'con-
nect the quick connect
hose
to
the
typical rinsing
hoses at most dumping
stations.
Use
of a differ-
ent hose will insure that
you
will
not
contaminate
your fresh water
supply.
CAUTION
The sewer drain valve
must
be
open when using
the
SAN-T-FLUSH inlet.
PACE
ARROW
To Next Page
Loading...
Need help?
General
