LiviNq
WiTh
YOUR
MOTOR
HOME
The monitor panel allows you
to
conveniently check the
approximate levels in the water tanks and to check battery
condition(s).
Electrical probes installed in the tanks measure the levels at
various points in the tanks.
To
check
tank
levels:
Press LP GAS, FRESH WATER, GRAY or BLACK TANK
switches.
The E or empty indicator
light will always be lit when the
rocker switches are depressed.
If the tank
is
full, all lights
will
be on. Lights are sequential, and indicate level
in
approximately V,-tank increments. If the tank selected
is
approximately 'I2-full, for example, lights
E,
'14
and
'12
will be
on.
Erroneous
tank
level indications
can
be caused by:
a.
Water with low mineral content. The level is measured by a
very
low level electrical signal traveling through the liquid.
Some water may not conduct the signal properly. This con-
dition may be infrequent, but can exist. Check the
panel
reading when the fresh water tank is filled.
b.
Material trapped on the sides of the holding tanks may give
a
full reading when the tank is actually empty.
To check
the
battery
charge:
1.
Unplug the 120-volt
AC
power cord to turn the power con-
verter olf.
2.
Press BATTERY rocker switch on the panel.
3.
Turn on a light or any 12-volt appliance. The battery must
be checked with a
load.
4.
Read battery condition on the meter. Red is
low,
yellow
is
fair and green
is
good.
MONITOR
PANEL
~I
NOTE
If
the sensor probes
mounted
in
the
tanks get
coated
with
grease,
the
monitor panel may indi-
cate falsely
or
not at all.
Avoid pouring grease,
oils
or
similar substances
down
drains or the toilet.
If this
is
unavoidable,
the
holding tank(s) should be
washed out with
a soapy
water solution.
See your
dealer for additional
information.
PACE Annow
\
te-
l'-
To Next Page
Loading...
Need help?
General
