PlVMbiNq
SYSTEMS
To
disconnect the city water:
1.
Turn OFF the city water supply.
2.
Remove the hose from the city water supply valve.
3.
Drain and store the hose.
The
on-board fresh water
tank
can be filled in two ways:
(1) city water pressure
or
(2) gravity.
1.
City water pressure - When connected to the city water
supply as described above, open the tank fill valve and
remove the fresh water tank fill cap and vent plug.
Make sure the external gravity fill connection is open
(remove the cap) to allow air to escape from the on-board
tank. When water
flows out of this external fill, the on-board
tank
is
full.
After filling, close the valve, replace the tank fill cap and
vent plug.
2.
Gravity fill
-The
external gravity water fill
is
located on the
exterior of the motor home. The on-board water tank can be
filled here.
To
fill the fresh water tank, remove the cap,
remove the vent plug, and fill the tank using a potable water
hose.
Check the monitor
panel often to determine if the tank
is
full. If water is flowing from the top vent, your tank
is
full.
Stop filling. Replace
the vent plug and filler cap.
FILLING
THE
ON"BoARD
WATER
TANK
CAUTION
Overfilling the fresh water
tank from a pressurized
source will cause serious
damage to the water tank
or
structural components.
Monitor water tank
filling
continually.
PACE
ARROW
To Next Page
Loading...
