37
SMS 305 18-EC
Additional safety warnings for
miter saw
Wear eye protection!
Keep hands and body out of the path
of the saw blade. Contact with blade will
result in serious injury.
Check guarding system to make sure it is
functioning correctly.
Never reach around saw blade.
Turn off the saw and wait for saw blade
to stop before moving workpiece or
changing settings.
Never stand on the power tool. Serious
injuries can occur when the power tool tips
over or when inadvertently coming into
contact with the saw blade.
Make sure that the guard operates
properly and that it can move freely.
Never lock the guard in place when
opened.
Never remove cutting remainders, wood
chips, etc. from the sawing area while
the machine is running. Always guide the
tool arm back to the neutral position first
and then switch the machine off.
Guide the saw blade against the
workpiece only when the machine is
switched on. Otherwise there is damage
of kickback, when the saw blade becomes
wedged in the workpiece.
Keep handles dry, clean, and free from
oil and grease. Greasy, oily handles are
slippery causing loss of control.
Operate the power tool only when the
work area to the workpiece is clear of
any adjusting tools, wood chips, etc.
Small pieces of wood or other objects
that come in contact with the rotating saw
blade can strike the operator with high
speed.
Keep the floor free of wood chips and
material remainders. You could slip or
trip.
Always firmly clamp the piece to be
worked. Do not saw workpieces that
are too small to clamp. Otherwise, the
clearance of your hand to the rotating saw
blade is too small.
Use the machine only for cutting the
materials listed under Intended Use.
Otherwise, the machine can be subject to
overload.
If the saw blade should become
jammed, switch the machine off and
hold the workpiece until the saw blade
comes to a complete stop. To prevent
kickback, the workpiece may not be
moved until after the machine has come
to a complete stop. Correct the cause
for the jamming of the saw blade before
restarting the machine.
Do not use dull, cracked, bent or
damaged saw blades. Unsharpened or
improperly set saw blades produce narrow
kerf causing excessive friction, blade
binding and kickback.
Always use saw blades with correct size
and shape (diamond versus round) of
arbor holes. Saw blades that do not match
the mounting hardware of the saw will run
eccentrically, causing loss of control.
Do not touch the saw blade after
working before it has cooled. The saw
blade becomes very hot while working.
Never operate the machine without
the insert plate. Replace a defective
insert plate. Without flawless insert plates,
injuries are possible from the saw blade.
Store the machine in a safe manner when
not being used. The storage location
must be dry and lockable. This prevents
the machine from storage damage, and
from being operated by untrained persons.
Secure the workpiece. A workpiece
clamped with clamping devices or in a vice
is held more secure than by hand.
Never leave the machine before it has
come to a complete stop. Cutting tools
that are still running can cause injuries.
Instructions to avoid overheating the
saw blade tips and, if cutting plastics is
permitted, to avoid melting the plastic.
Noise and vibration
The noise and vibration values have been
determined in accordance with
EN 62841-3-9.
The A evaluated noise level of the power tool
is typically:
–
Sound pressure level L
pA
: 93 dB(A)
–
Sound power level L
WA
: 106 dB(A)
–
Uncertainty: K = 3 dB
To Next Page
Loading...
