Flex SMS 305 18-EC - Technical Data

38
SMS 305 18-EC
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardised in EN 62841-3-9 and may be
used to compare one tool with another.
That the declared vibration total value(s) and
the declared noise emission value(s) may
also be used in a preliminary assessment of
exposure.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary
to take into account the times when the tool
is switched off or running but not actually in
use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
cutting accessories, keep the hands warm,
organization of work patterns.
WARNING!
that the vibration and noise emissions
during actual use of the power tool
can differ from the declared values
depending on the ways in which the tool
is used especially what kind of workpiece
is processed; and
of the need to identify safety measures
to protect the operator that are based on
an estimation of exposure in the actual
conditions of use (taking account of all
parts of the operating cycle such as the
times when the tool is switched off and
when it is running idle in addition to the
trigger time).
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
Technical data
Tool SMS 305 18-EC
Type Miter Saw
Rated voltage V 18
No load speed /min 4000
Blade diameter mm 305
Blade arbor
hole diameter
mm 30
Max. thickness
of the saw teeth
mm 2.5
Max. miter
angle
° 60° right, 52° left
Max. bevel
angle
° 48° right, 48°left
Miter detents
left
°
45°; 31.6°; 22.5°;
15°; 0°
Miter detents
right
°
45°; 31.6°; 22.5°;
15°; 0°
Bevel stops left ° 45°; 33.9°; 22.5°; 0°
Bevel stops
right
° 45°; 33.9°; 22.5°; 0°
Weight
according
to”EPTA
Procedure
01/2003”
kg 25.5
Battery 18V
AP 18.0/2.5
AP 18.0/5.0
AP 18.0/8.0
Weight of
battery
kg
AP 18.0/2.5
AP 18.0/5.0
AP 18.0/8.0
0.4
0.7
1.1
Working
Temperature
-10
󰦊
40℃
Storage Tem-
perature
-40
󰦊
70℃
Charging
temperature
4~40℃
Charger
CA 12/18
CA 18.0-LD
CA 10.8/18.0