Instruction manual XFE 15 18.0-EC / XCE 8 18.0-EC
14
Display flashes rapidly.
Backlighting red.
Remove the battery from the
charger and insert again. If the same display
persists, the battery is faulty. Replace the
battery or have it checked at an authorised
repair shop.
If this error message is displayed again with
a different battery, this indicates that there
is a fault in the charger. Have the charger
checked at an authorised repair shop.
Maintenance and care
WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always remove
the battery.
Storage
Ambient temperature range for use of tool
and batteries is 0 °C … 40 °C.
Ambient temperature range for storage of
tool and batteries is -25 °C … +85 °C.
Cleaning
Regularly clean the power tool and venti-
lation slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
CAUTION
Risk of injury! Wear safety glases while
using compressed air.
All plastic parts should be cleaned with soft
damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve
or otherwise damage the material.
– Clean the power tool and grille in front of
the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
– Regularly blow out the housing interior
and motor with dry compressed air.
– Regularly clean the filter cover.
Remove filter cover and blow it out with
dry compressed air.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and void.
Change Velcro pad
– Remove the battery.
– Remove the polishing tool.
– Place machine on its back.
– Release and remove screws with
wrench (1.).
– Remove worn Velcro pad (2.).
– Remove contaminants from interior.
To Next Page
Loading...
Need help?
General
