XFE 15 18.0-EC / XCE 8 18.0-EC Instruction manual
15
– Align securing holes and fit new Velcro
pad (3.).
– Insert screws and tighten with wrench (4.).
(Tightening torque 2.5-3.0 Nm
(1.8-2.2 ft. lb.))
– Carry out test run. Check for imbalances
and vibrations.
CAUTION
An incorrect torque setting can damage
the tool and the surfaces being worked on.
Repairs
All quality tools will eventually require
servicing or replacement of parts due to
wear from normal use. These operations,
including brush inspection and replacement,
should ONLY be performed by an
authorized service center for FLEX Power
Tools. All repairs made by these agencies
are fully guaranteed against defective
material and workmanship.
We cannot guarantee repairs made or
attempted by anyone other than these
agencies.
Should you have any questions about your
tool, feel free to write us at any time. In any
communications, please give all information
shown on the nameplate of your tool (model
number, type, serial number, etc.).
Spare parts and accessories
NOTE
Only the tools released by FLEX may be used.
For other accessories, in particular tools
and polishing aids, see the manufacturer’s
catalogues.
Exploded drawings and spare-part lists
can be found on our homepage:
www.flex-tools.com
Warranty
FLEX North America limited one
year Warranty
FLEX North America warrants its Profes-
sional Power Tools for a period of one year
from the date of original purchase. We will
repair or replace at our option, any part or
parts of the product and accessories covered
under this warranty, which, after examination,
prove(s) to be defective in workmanship or
material during the warranty period. For repair
or replacement, return the complete tool or
accessory, transportation prepaid, to your
nearest Authorized Service Station.
To Next Page
Loading...
Need help?
General
