To Next PageTo Next Page
Need help?Do you have a question about the FlexArm GH-18 and is the answer not in the manual?
General| Brand | FlexArm |
|---|---|
| Model | GH-18 |
| Category | Industrial Equipment |
| Language | English |
Mount arm in pivot, adjust counterbalance to prevent operator striking.
Connect to 110V supply, check hydraulic motor clockwise rotation.
Wear safety glasses, secure workpiece, avoid gloves during operation.
Designed for tapping up to M18, manufacturer not liable for misuse.
Plug in, engage lockout breaker, press green button for 2-3 seconds.
Press red button, disengage lockout breaker after motor spool down.
Common causes: incorrect button order, premature power removal, unplugging before motor spool down.
Steps to reset: breaker off, unplug, wait, plug in, breaker on, press green button.
One year warranty against manufacturer defects; excludes misuse or incorrect connections.
FlexArm units feature a standard tap lubricator system.
Connect air, fill oil tank to maximum level.
Use starting lever, adjust oil mixture with regulator.
Avoid corrosive oils to prevent damage to plastic valves.
Adjust tapping head position using large and small levers.
Verify small lever is loose for proper tapping.
Ensure both levers are secure when returning head to vertical for tapping.
