FlexRadio FLEX-6300 User Manual

Page 1 © 2022 FlexRadio, v1.0.0
FLEX-6300 MicroSD Card
Installation Guide
May 4, 2022
The following guide will provide the necessary step-by-step procedure for installing a MicroSD
card in a FLEX-6700 or FLEX-6500.
Table of Contents
GETTING STARTED ......................................................................................................................... 2
Required Tools ......................................................................................................................... 2
Materials needed for Service Procedure .................................................................................. 2
PREPARING TO INSTALL THE MICROSD CARD ....................................................................... 2
Removing the Top Cover ......................................................................................................... 2
REPLACING THE EXISTING MICROSD CARD .................................................................................... 4
Locating and Removing the RF Isolation Cover....................................................................... 4
Remove the existing MicroSD Card ......................................................................................... 5
Remove the existing MicroSD Card ......................................................................................... 6
INSTALLING THE NEW MICROSD CARD ............................................................................................ 7
Installing the New MicroSD Card in the Card Socket .............................................................. 7
Verify the FLEX-6300 will boot properly with the new MicroSD Card .................... 8
Reinstall RF Isolation cover ...................................................................................................... 8
REINSTALLING THE TOP COVER ............................................................................................... 9

FlexRadio FLEX-6300 Specifications

General

Receiver Type	Direct Sampling
Transmitter Output Power	100 W
Modes	SSB, CW, AM, FM, Digital
A/D Resolution	16-bit
ADC Sample Rate	122.88 MSPS
Antenna Connectors	2 x SO-239
DAC Resolution	16-bit
Sample Rate	122.88 MSPS
Power Supply	13.8 VDC
Frequency Range Transmit	1.8 – 54 MHz
Display	External
Interface	Ethernet

Summary

Getting Started

Required Tools

Lists essential tools like screwdrivers and wrenches for the installation procedure.

Materials needed for Service Procedure

Lists the new MicroSD card and Kapton tape required for the installation.

Preparing to Install the MicroSD Card

Removing the Top Cover

Details how to remove the top chassis cover using specific screws and tools for access.

Replacing the Existing MicroSD Card

Locating and Removing the RF Isolation Cover

Explains how to find and remove the RF isolation cover, including handling a warranty sticker.

Remove the existing MicroSD Card

Guides on locating and carefully removing the current MicroSD card from its slot.

Installing the new MicroSD Card

Installing the New MicroSD Card in the Card Socket

Instructs on properly seating the new MicroSD card and securing its retaining clip.

Verify the FLEX-6300 will boot properly with the new MicroSD Card

Outlines connecting power and network to confirm the radio boots correctly after card installation.

Reinstall the RF Isolation cover

Reinstalling the Top Cover