Page 6 © 2022 FlexRadio, v1.0.0
Gently slide the silver MicroSD card retaining clip away from the FPGA processor/fan assembly
so that it releases and lifts as shown below.
Remove the existing MicroSD Card
The next step is to remove the MicroSD card from the FLEX-6300.
Using a non-metallic object to lift the end of the card nearest to the FPGA processor/fan
assembly, the MicroSD card should easily lift out of the card socket so it can be removed.
Also, you may want to take the opportunity to blow out the dust from the CPU and FPGA fans
while you have the RF can cover removed. Just make sure you do not over spin the small CPU
and FPGA fans when cleaning them by placing a small non-metallic object like a toothpick into
the fan blades to prevent them from spinning freely.
To Next Page
Loading...
