Page 8 © 2022 FlexRadio, v1.0.0
Verify the FLEX-6300 will boot properly with the new MicroSD Card
Before installing the top cover on the FLEX-6300, verify the radio boots properly.
Connect a 13.8v power supply to the DC input.
Connect an Ethernet cable to the radio and connect it to your LAN
Turn the FLEX-6300 on and verify the radio boots without an error and the Power LED is solid
green.
Note: If the FLEX-6300 does not boot, then power down the radio, remove the DC power cable,
reseat the MicroSD card, power up the FLEX-6300 and reseat the MicroSD card.
Reinstall the RF Isolation cover
Reinstall the RF Isolation cover. Make sure that the RF Isolation cover is inserted properly in the
RF shield housing’s retaining tabs. Starting at one corner ensure that the cover is between the
alternating rows of “teeth” to ensure the cover is aligned properly. Once installed it should like the
image below.
To Next Page
Loading...
