FlexRadio FLEX-6400 Installation Instructions

Step 5: Where the 4 screws were removed above, replace with the 4 stand offs included in the kit as
show below.
Step 6: Remove ATU from bag and insert the two cables provided as shown. Both cables should be
inserted from the top with the straight connector going through the grommet and the right-angle
connector on top. The longer of the two cables goes through the grommet nearest the inductors with
the most coils.

FlexRadio FLEX-6400 Specifications

General

Brand	FlexRadio
Model	FLEX-6400
Category	Transceiver
Language	English