EasyManua.ls Logo

Flint & Walling SP20P1 - User Manual

Default Icon
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
LAWN SPRINKLER,
IRRIGATION PUMP
MODEL #
, SP10P1, SP15P1, SP20P1,
EL10P1, EL15P1, EL20P1
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product. If you have any questions regarding the product, please call customer service at
1-800-742-5044, 7:30 a.m.-5:00 p.m., EST, Monday-Friday.
DANGER
ELECTRICAL SHOCK HAZARD.
Always disconnect power source before performing
any work on or near the motor or its connected load.
If the power disconnect point is out-of-sight, lock it in
the open position and tag it to prevent unexpected
application of power. Failure to do so could result in
fatal electrical shock.
ELECTRICAL SHOCK HAZARD.
Do not handle the pump with wet hands or when
standing in water as fatal electrical shock could occur.
Disconnect main power before handling unit for ANY
REASON!
RISK OF ELECTRIC SHOCK.
These pumps have not been investigated for use in
swimming pool areas.
WARNING
ELECTRICAL SHOCK ALERT.
Follow all local electrical and safety codes, as well
as the National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
ELECTRICAL SHOCK ALERT.
Replace damaged or worn wiring cord immediately.
ELECTRICAL SHOCK ALERT.
Do not kink power cable and never allow the cable
to come in contact with oil, grease, hot surfaces, or
chemicals.
ELECTRICAL SHOCK ALERT.
Unit must be securely and adequately electrically
grounded. This can be accomplished by wiring the unit
to a ground metal-clad raceway system or by using a
separate ground wire connected to the bare metal of
the motor frame or other suitable means.
CHEMICAL ALERT.
This product contains chemicals known to the State of
California to cause cancer and birth defects or other
reproductive harm.
CAUTION
ELECTRICAL SHOCK MAY OCCUR
Protect the power cable from coming in contact with
sharp objects.
HOT SURFACE MAY CAUSE BURNS
Be careful when touching the exterior of an operating
motor - It may be hot enough to be painful or cause
injury.
PRODUCT DAMAGE MAY RESULT
Make certain that the power source conforms to the
requirements of your equipment.
023264 G
Question and Answer IconNeed help?

Do you have a question about the Flint & Walling SP20P1 and is the answer not in the manual?

Flint & Walling SP20P1 Specifications

General IconGeneral
ModelSP20P1
CategoryWater Pump
Horsepower2 HP
Max Flow Rate90 GPM
Suction Lift25 ft
MaterialCast Iron
PhaseSingle

Summary

Safety Information

DANGER

Electrical shock hazards and warnings for safe operation.

Preparation

Pump Electrical Instructions

WARNING

Alerts about under-sized wiring and motor failure.

ELECTRICAL SHOCK ALERT

Warnings about wiring, grounding, and power disconnection.

ELECTRICAL SHOCK MAY OCCUR

Advice on hiring qualified electricians and circuit breakers.

Pump Electrical Connections

To change from 230 V to 115 V

Instructions for changing motor voltage.

Pump Priming & Startup

CAUTION: All pumps must be primed

Importance of priming the pump cavity with water.

IMPORTANT: If the pump fails to prime

Troubleshooting steps for priming failure.

IMPORTANT: If the pump hums instead of pumping

Troubleshooting steps for motor humming or tripping.

Maintenance

ROTARY SEAL ASSEMBLY REPLACEMENT

Detailed steps for replacing the rotary seal assembly.

Troubleshooting

A. Little or no discharge

Possible causes and corrective actions for no discharge.

B. Pump will not deliver water or develop pressure

Troubleshooting steps for low or no water delivery.

C. Loss of suction

Causes and solutions for loss of pump suction.

D. Pump vibrates and;or makes excessive noise

Diagnosing and fixing pump vibration or noise issues.

E. Pump will not start or run

Troubleshooting steps for a pump that won't start.

F. Pump loses prime.

Causes and corrective actions for losing prime.

Related product manuals