Using the Main Menu13
To configure snapshot recording settings:
1. From the Main Menu, click
and select Recording > Snapshot.
2. Under Snapshot, select the number of snapshots the NVR will take when the snap-
shot button is pressed.
3. Configure the following settings for snapshots saved automatically from motion detec-
tion or the snapshot schedule:
• Channel: Select the channel you would like to configure.
• Mode: Select Timing for the system to take snapshots according to the snapshot
schedule (see 13.3.16 Configuring the Snapshot Schedule, page 82). Select Trig-
ger for the system to take snapshots only when triggered by motion detection
(snapshot must be enabled in the Motion Detect menu; see 13.3.8 Configuring Mo-
tion Detection, page 73).
• Image Size: The image size is the same as the Main Stream resolution of the
camera.
• Quality: Select the snapshot image quality between 1 (lowest) and 6 (highest).
• Snapshot Frequency: Select the number of snapshots (up to 6) the NVR will take
each time.
4. Click Apply and OK to save changes.
13.1.9 Creating Custom Channel Names
You can assign custom names to your cameras. For example, you can name your cameras
based on their location (e.g. hallway or front door).
To create custom channel names:
1. From the Main Menu, click
and select Channel Name.
#LX400094; r.43927/43955; en-US
57
To Next Page
Loading...