FLIR DNR218 - Configuring Hard Drive Warnings

Using the Main Menu13
2. Under Channel, select the channel you would like to configure.
3. Check Enable to enable video tamper alarm for the selected channel.
4. Configure the following to customize settings for video tamper events:
• Period: Click Set to configure a schedule when video tamper alarm will be acti-
vated. It is recommended to leave this on the default setting, so you will be alerted
any time one of your cameras is tampered with.
• Show Message: Check to show a popup message on the monitor if one of your
cameras is tampered with.
• Send Email: Check to enable email alerts. Enabling Send Email requires you to
set up email notifications. See13.3.5 Configuring Email Alerts, page 70) for full
instructions.
• Channels: Check to enable video recording when video tamper occurs.
• PTZ Activation: Check to enable PTZ actions when video tamper occurs (PTZ
camera required; not included). Click Set to select which PTZ actions will be taken
by each camera.
• Post_REC: Enter the number of seconds the system will record after video tamper
occurs.
• Sequence: Check to enable a custom sequence mode when video tamper occurs
on the selected channel. Then click the channels you would like to display in the
custom sequence mode.
• Snapshot: Check to save a snapshot when video tamper occurs.
• Buzzer: Check to enable the system buzzer when video tamper occurs on the cur-
rently selected channel.
5. Click OK to save changes.
13.3.11 Configuring Hard Drive Warnings
Hard drive warnings will notify you if an issue is detected with the hard drive.
#LX400094; r.43927/43955; en-US
78