6 Quick Start Guide
Procedure
Follow this procedure to get started right away:
Remove the protective film from the LCD.1
You must charge the battery inside the camera for four full hours (or until
the battery charging indicator displays a green light) before you use the
camera for the first time.
Charge the battery by connecting the power supply to the power connector
on the camera. Make sure that you use the correct AC plug.
Note: The first time you charge a factory-new battery you must turn on and
then turn off the camera after you have connected the power supply to the
power connector on the camera.
T630175;a1
1 Battery charging indicator
2 Power supply cable
2
Insert a miniSD™ memory card into the card slot.
T630176;a1
3
Publ. No. T559580 Rev. a486 – ENGLISH (EN) – November 17, 2010 7
To Next Page
Loading...
Need help?
General
