3—Operating Your H-Series Camera H-Series Operator’s Manual
10 March 2012
3–2 Installing the SD Card and Batteries
The batteries must be installed and charged before using your
camera. Also install the SD card at this time.
1. Remove the small SD card
door. No tools are required.
This will help when removing
the battery cover.
2. Loosen the four captive screws
securing the battery cover.
3. Pry off the battery cover by
grasping the front edge
exposed where the SD card
cover was removed.
4. Install the batteries as shown.
5. Install the SD card.
6. Snap the SD card door back into place, ensuring that the rubber
lanyard retracts into the camera.
7. Re-install the battery cover—it only fits one way.
8. Tighten the four screws.
If you have installed rechargable batteries, they must be charged
before using the camera. Regular AA batteries will provide about one
and a half hours of camera use.
Grasp SD card door edges and pull
Battery
cover
HS_Series_Operators.book Page 10 Thursday, March 29, 2012 3:03 PM
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
