H-Series Operator’s Manual 3—Operating Your H-Series Camera
431-0003-01-10, Revision 160 15
Capture Button–Pro (Command version) only
Use this button to capture snapshots (in JPEG format) or
video clips (in AVI format). The files are stored on the
integrated SD card. AVI files are viewable via the FLIR Viewer Utility
included on the H-Series resource CD.
• Momentarily pressing the button captures a single snapshot.
• Pressing and holding the capture button for three seconds puts
the camera in video record state. The video record icon should be
displayed. The button may now be released and the camera will
continue to record until the capture button is pressed again. The
video file is then written to the SD card in AVI format.
Twenty-five seconds of video requires about one megabyte (MB) of
storage on the SD card. The image and video files must be transferred
to a computer for viewing.
Note
• If the camera is not a Pro model,
this message will be shown in the
display.
• If an SD card is not installed, this
message will be shown in the
display and no image will be stored.
• If the SD card is full, a warning will
be shown in the display and the
image will not be stored.
Note
The images must be transferred to a computer via the USB cable,
or the SD card can be temporarily removed from the camera and
inserted in a card reader.
The stored image will include the thermal image, time and date
information, and the FLIR logo. Other icons seen in the display are
not stored on the saved image.
HS_Series_Operators.book Page 15 Thursday, March 29, 2012 3:03 PM
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
