FLIR Lepton 1.6 - The Information Contained Herein Does Not Contain Technology as Defined by the EAR, 15 CFR 772, Is Publicly Available

FLIR LEPTON® Engineering Datasheet
The information contained herein does not contain technology as defined by the EAR, 15 CFR 772, is publicly available,
and therefore, not subject to EAR. NSR (6/14/2018).
Information on this page is subject to change without notice.
Lepton Engineering Datasheet, Document Number: 500-0659-00-09 Rev: 203
43
Parameter
Power-On
Default
Section in this document
SYS Scene Stats ROI
12
(startCol, startRow, endCol, endRow)
(0,0,79,59) or
(0,0,159,119)
SYS FFC Mode
Auto
FFC States, page 18
SYS FFC Period
180000
FFC States, page 18
SYS FFC Temp Delta
150
FFC States, page 18
SYS Gain Mode
High
Gain States, page Gain States 22
VID Color LUT Select
Fusion
Video Output Format Modes, page 36
OEM Video Output Format
Raw14
Video Output Format Modes, page 36
OEM GPIO Mode
Disabled
GPIO Modes, page 39
OEM GPIO VSYNC Phase
Delay
0 lines
Frame Synchronization, page 53
RAD Radiometry Control
Enabled
Radiometry Modes, page 29
RAD TLinear Enable State
Enabled
Radiometry Modes, page 29
RAD TLinear Resolution
0.01
Radiometry Modes, page 29
RAD Spotmeter ROI
(startCol, startRow, endCol, endRow)
(29,39,30,40) or
(59,79,60,80)
Radiometry Modes, page 29
RAD Flux Linear Parameters
(8192, 29515,
8192, 29515,
8192, 29515, 0,
29515)
Radiometry Modes, page 29
This feature is intended to be performed at the OEM’s factory, because it requires an additional voltage supply
and pin connection that should not be connected in run-time operation. The Lepton module pin connection for
the programming voltage is described in Table 8 below, and the electrical specifications for the supply are
defined in Table 9 below.