FLIR LEPTON® Engineering Datasheet
The information contained herein does not contain technology as defined by the EAR, 15 CFR 772, is publicly available,
and therefore, not subject to EAR. NSR (6/14/2018).
Information on this page is subject to change without notice.
Lepton Engineering Datasheet, Document Number: 500-0659-00-09 Rev: 203
66
6.1 Socket Information
The Lepton module is compatible with two commercially-available sockets, Molex 105028-1001 and Molex
105028-2031, illustrated in Figure 44 below. The former makes electrical contact on the upper surface of a
printed circuit board, the latter to the lower surface (with a cutout in the board that allows the socket to fit into).
In both cases solder connections are made to the top or “component” side of the board. Figure 45 depicts both
socket configurations mounted on a PCB.
To order sockets, visit www.arrow.com.
Figure 44 - Two Commercially-available Sockets (both from Molex) Compatible with Lepton
To Next Page
Loading...