Handling the camera13
3. Align the new eyecup with the eyecup mount on the camera.
4. Carefully slide the eyecup into position.
13.14 Using the camera lamp as a flash
13.14.1 General
The camera lamp can be used as a flash for the digital camera. When the flash function
is activated, the camera lamp will flash when an image is saved by pushing the Autofo-
cus/Save button fully down.
13.14.2 Procedure
Follow this procedure:
1. Push the joystick to display the menu system.
2. Use the joystick to go to
(Settings).
3. Push the joystick to display the Settings menu.
4. Select Device settings and push the joystick.
5. Select Set up camera and push the joystick.
6. Select Lamp & laser and push the joystick.
7. Select Enable lamp & laser. If the check box is unchecked, push the joystick to ena-
ble the camera lamp.
8. Select Use lamp as flash. If the check box is unchecked, push the joystick to activate
the flash function.
#T559880; r. AK/36075/36075; en-US
33
To Next Page
Loading...
Need help?
General
