Programming the camera (time-
lapse)
16
You can program the camera to save images periodically (time-lapse).
Follow this procedure:
1. Push the navigation pad to display the menu system.
2. Select
(Recording mode) and push the navigation pad. This displays a submenu.
3. Select
(Time-lapse).
4. Push the navigation pad. This displays a dialog box where you can set the save
conditions:
• Save interval: Use the navigation pad to set the time interval between each saved
image.
• Total number of images: Periodic saving will stop when the set number of images
have been saved.
Note If you select “∞,” the camera will keep on saving images until the memory
card is full or until you manually stop the time-lapse.
5. Push the navigation pad. This closes the dialog box.
6. The time interval is displayed at the top of the screen.
7. To start the time-lapse (periodic saving), push the Save button.
8. To manually stop the time-lapse, push the Save button.
9. When the time-lapse is completed, an information screen is displayed. Push any but-
ton or touch the screen to return to the live image.
#T810413; r. AF/83467/83910; en-US
76
To Next Page
Loading...
