FLIR TG56 - Maintenance; Battery Replacement; Calibration; Cleaning


FLIRTG54_TG56UserManual21DocumentIdentifier:TG54_TG56‐en‐US_AA
7Maintenance
7.1BatteryReplacement
 TheTGSeriesispoweredbythree(3)1.5V‘AAA’batteries.
 Thebatteriesarelocatedinatrayhousedinsidethemeterhandle.Toaccessthebattery
tray,unscrewthecapatthebottomofthemeterhandle.
 Slidethebatterytrayoutofthehandle,notingthe
trayorientation.
 Replacethebatteriesobservingcorrectpolarity.
 Slidethebatterytraybackintothehandleintheoriginalorientation.
 Screwthecapbackontothehandle.
7.2Calibration
Themeteriscalibratedatthefactorypriortoshipment.Ifcalibrationisrequired pleasecontact
alocalFLIRservice center. TheTGSeriesisnot user‐serviceableandshould onlybecalibrated
bytrained,qualifiedFLIRpersonnel.
7.3Cleaning
Wipethehousingwithadryordampclothasneeded.Useahighqualitylenswipetoremove
dirt or smudges from the meter lenses and display window. Please do not use abrasives or
solventstocleanthemeterhousing,lenses,ordisplaywindow.

